Products
Seamless Tube
Heat Efficiency Tube
Welded Pipe (ERW/HFW)
Welded Pipe (SAWL)
Welded Pipe (SAWH)
Pipe Fitting and Flange
Q345 seamless torque tube notes
Note Q345 seamless pipe, the use rate is very high, but the general construction before the construction, the pipe, pipe fittings, rubber ring and so on to do an appearance inspection, found that there is a problem to give up the use of.
1. Q345 seamless tube cleaning moment: Bearing all the debris removal clean mouth.
2. Cleaning apron, apron: adhesive material on the apron clean up, put the ring bending "quincunx" or figure 8 into the socket slot, and hand along the entire ring press again, or with a rubber hammer, to ensure that each part of the warping apron is not twisted, uniform card in the slot.
3. Jack painted on the outer surface and rubber lubricant: lubricant evenly installed ring inner surface, outer surface coating in the socket to socket socket parts lubricant line all the brush in the socket.
4. Down pipe: the requirements of the pipe should be pressed down to the bottom of the Q345 seamless pipe, usually by the pipe under the tube or mechanical method.
5. Installation equipment: the equipment will be ready equipment installed in place, attention should not be installed to clean up the Q345 seamless pipe parts of the pollution again.
6. Push Q345 seamless rectangular tube into socket in installation, in order to socket is inserted into the socket is easy and smooth. The socket and socket into socket to the pressure in the port of rubber ring, connect the wire rope and chain chain tension; until the socket is inserted into the socket are in place between the socket and the socket should be 2mm about the gap, and ensure the socket around the outer ring to the same distance.